Procedures · 01

Acid base titration

Determine the molarity of an alkali using a primary standard acid, the core skill behind every volumetric experiment.

You will need

  • 50 mL burette and stand
  • 10 mL or 20 mL pipette with a pipette filler
  • 250 mL volumetric flask
  • Conical flasks (250 mL)
  • Funnel, white tile, wash bottle
  • Weighing bottle and analytical balance

Safety

  • NaOH is corrosive: wear goggles and gloves
  • Never pipette by mouth; always use a filler
  • Fill the burette below eye level with a funnel, then remove the funnel

Procedure

0 of 7 done

Calculation

Oxalic acid is diprotic, so nacid×2=nNaOHn_{\text{acid}} \times 2 = n_{\text{NaOH}}.

MNaOH=2 Macid VacidVNaOHM_{\text{NaOH}} = \frac{2\,M_{\text{acid}}\,V_{\text{acid}}}{V_{\text{NaOH}}}

Example: 10.0 mL of 0.050 M acid needs 10.0 mL of NaOH, so MNaOH=2×0.050×10.0/10.0=0.10M_{\text{NaOH}} = 2 \times 0.050 \times 10.0 / 10.0 = 0.10 M.

Common mistakes

  • Air bubble left in the burette tip, so the reading is too high
  • Rinsing the conical flask with the acid adds extra acid; rinse it with water only
  • Reading the top of a colourless meniscus, or reading at an angle (parallax)
  • Overshooting the end point with a dark pink colour

Volumetric analysis chapter